Underline Start/Underline Stop - Xerox 4213 Programmer's Reference Manual

Where to place it

Underline Start/Underline Stop

Where to place it
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE
Anywhere bolding is desired, enter the Bold Start command
immediately before the first character to be bolded and the Bold
Stop command immediately after the last character to be bolded.
Example To produce:
It is possible to bold text without using a bold font; simply
insert the appropriate commands.
Enter:
It is possible to bold text
E psimply insert the appropriate commands.
More In most cases, using a bold font gives better results, especially
for large sections of text.
Purpose Underlines text.
Syntax
E
u
Syntax
E
w
Instruction to start underlining.
u
Instruction to stop underlining.
w
Anywhere underlining is desired.
Example To produce:
It is possible to underline text by using the following
commands: Underline Start and Underline Stop.
Enter:
It is possible to underline text
commands E w: Underline start and Underline stop.
More Both the thickness of the underline and its distance from the
character it underlines are determined by the size of the current
font in the line. So if you underline in a large font and then
change to a small font for the text in the next line, you may want
to enter the Font Change command for the smaller font before
entering the line end. This will prevent the underline for the
larger font from crowding the smaller characters on the next line.
The underline character prints under the character descender.
XES COMMAND LANGUAGE MODE
E bwithout using a bold font;
E uby using the following
2-69