Font Select - Xerox 4213 Programmer's Reference Manual

Font Select

Where to place it
Setting units of measure
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE
Purpose Selects a font from those listed in the index created with Font ID
Assignment.
Syntax
E n
The ID number for the font, from 0 to 9.
n
Anywhere in the document at which you want to use this font.
Example From the following index:
E +0Classic8iso-L
E
+1Classic8Biso-L
E
+2Classic6iso-L
E +3Classic12iso-L
E +4Classic10iso-L
to select Classic8Biso-L within a document, enter:
E
1
More If you specify a number that is not assigned first with a Font ID
Assignment, the printer continues printing with the current font.
An error message appears on the Summary Sheet.
To select the default landscape font (without having assigned a
font ID), use E
To select the default portrait Titan font (without having assigned
a font ID), use E
You may want to select
font to identify the page orientation.
determines the orientation of the page.
Margins and tabs are set either in units of five pixels (1/60 inches)
or in units of one pixel (1/300 inches). You select the unit of
measure by entering Units—1/60th or Units—1/300th. The Units
commands are entered before those for margins or tabs settings.
They need not be entered immediately before, however. You do
not need to enter a Units command more than once in a job.
XES COMMAND LANGUAGE MODE
L
L
L
L
L
0.
1.
either the default portrait or landscape
The first font called out
2-37