LJ SERIES 2D EMULATION
Font Selection by ID
Font Descriptor
3-48
Notes
Temporary downloaded fonts are removed each time the
•
printer is reset.
through resets but are lost when the printer is turned off.
If the primary or secondary font is deleted, the font most
•
closely resembling the deleted font is chosen from the
remaining fonts to be the new primary or secondary font.
The Font Selection by ID command designates a downloaded
font as the primary or secondary font by its ID number.
are separate commands for selecting primary and secondary
fonts. The following command selects a primary font:
Syntax
E
(#X
Hex 1B 28 # 58
Dec 27 40 # 88
To select a secondary font enter:
Syntax
E
)#X
Hex
1B 29 # 58
Dec
27 41 # 88
where # is the font ID number.
Font assignment numbers on downloaded fonts may or may not
be consecutive.
and a gap does not imply anything is missing.
Purpose
The Font Descriptor command creates a header, or descriptor,
for a font being downloaded to the printer. The Font Descriptor
command normally follows a Font ID command.
Permanent downloaded fonts are retained
The numbers are only meant to be identifiers
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE
There