Xerox 4213 Programmer's Reference Manual page 84

XES COMMAND LANGUAGE MODE
Where to place it
2-46
Syntax
E
tn1,n2,...,n160
t
n1,n2,..,n160
L Line end.
At the start of the job or anywhere a horizontal tab is desired.
Example Figures 2-7 and 2-8 show a line of tabs across an 216 by 279 mm
portrait page. Figure 2-7 shows the settings in units of five pixels
(1/60 inches). Figure 2-8 shows the same settings in units of one
pixel (1/300 inches).
More Up to 160 horizontal tabs may be set per job. If you try to set
more, the printer will consider all tabs to the right of the last tab
setting as spaces. This will affect the appearance of the page.
Table 2-4. Default values for horizontal tabs
U.S.
Position portrait
1st tab 1.1 inch
28 mm
330 dots
Intervals 0.44 inch
11.2 mm
132dots
L
Instruction to set horizontal tabs.
Tab settings across the page starting from the left
edge. Up to 160 tabs can be set in one command.
Commas separate values. See table 2-4 for default
horizontal tab values for portrait and landscape
pages.
U.S. International
landscape portrait
1.1 inch 1.04 inch
28 mm 26.4 mm
330 dots 313 dots
0.44 inches 0.48 inches
11.2 mm 12.2 mm
132 dots 144 dots
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE
International
landscape
1.04 inch
26.4 mm
313 dots
0.48 inches
12.2 mm
144 dots