LJ SERIES 2D EMULATION
Raster Graphics Presentation Mode
Start Graphics
3-52
Table 3-12.
#
Graphics Resolution
75
75 spots per inch
100
100 spots per inch
150
150 spots per inch
300
300 spots per inch
Purpose
This command designates how the raster image will appear on
the logical page.
Syntax
E
*r#F
where # =
# =
Purpose
The Start Graphics command initialises the printer for subsequent
Transfer Raster Data commands and determines the location of
the left graphics margin.
The left graphics margin may be set at the left edge of the
printable area or at the current X value of the cursor position.
After receiving the Start Graphics command, the printer sets the
graphics resolution and left graphics margin until it receives an
End Graphics command.
Values for graphics resolution
0 - Raster graphics are printed in the orientation of
the logical page.
3 - Raster graphics are printed along the width of
the physical page, regardless of the orientation
of the logical page.
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE