Xes Command Language Mode; Configuring The 4213 For The Xes Command Language Mode; Automatic Mode Switching - Xerox 4213 Programmer's Reference Manual

Configuring the 4213 for the XES command language mode

Automatic mode switching

XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE
2.

XES command language mode

This chapter is for anyone using the Xerox Escape Sequence (XES)
emulation on the Xerox 4213 laser printer.
Please refer to the Xerox 4213 Laser Printer User Guide for
instructions on how to configure the 4213 printer to operate in
XES mode.
It is possible to have software loaded in the 4213 which enables
you to switch from
reconfiguring the printer.
change command and the reset command.
Be careful to copy the commands exactly as they appear,
including uppercase letters, punctuation, and spaces.
symbol L represents a carriage return (ASCII 13 or 0DH), line
feed (ASCII 10 or 0AH), or both, depending on your computer
system.
In the IBM PC Disk Operating System (DOS), carriage return and
line feed are automatically entered when you press the Return
key at the end of each line.
one emulation to another
This requires the use of the mode
without
The
2-1