Printer Reset; Job Control Commands; Number Of Copies - Xerox 4213 Programmer's Reference Manual

LJ SERIES 2D EMULATION

Job control commands

Printer Reset

Number of Copies

3-14
The job control commands affect an entire print job.
Purpose The Printer Reset command restores the printer to its default
settings. This command deletes any temporary fonts and macros
from memory and prints any data remaining in the printer buffer.
It is recommended to use the Printer Reset command at the
beginning of each job.
Syntax
E
E
Hex 1B 45
Dec 27 69
Purpose The Number of Copies command causes the 4213 to print a
specified number of copies for each page of data received until
either the number of copies is changed or a Printer Reset
command is issued.
within a page and acts on the current page and all subsequent
pages.
Syntax
E
&l#X
where is the number of copies to print between 1 and 99.
#
Example To select 10 copies of a single page of document, enter:
E
&l10X
Hex 1B 26 6C 31 30 58
Dec 27 38 108 49 48 88
This command can be issued anywhere
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE