Interfaces; Parallel Interface; Parallel Interface Cable - Xerox 4213 Programmer's Reference Manual

Parallel interface

The parallel interface cable
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE
1.
This chapter describes the interfaces supported by the 4213 Laser
Printer, the Centronics and Dataproducts parallel, and the serial
asynchronous.
The 4213 Laser
Centronics and Dataproducts. Each is described on the following
pages.
You must supply the interface cable to connect the 4213 to your
host. The cable must meet the following specification in order
to comply with FCC and VDE regulations.
Table 1-1.
Type:
No. of conductors:
Wire size:
Cable length:
Shield connection:
Note When connecting or disconnecting the parallel interface cable,
make sure the printer is off line.
Printer supports
interface cable specifications
Twisted pairs, overall foil or braid
shield
15 pairs
22 AWG stranded
Maximum length: Centronics or
Dataproducts—10 feet (3.05metres)
To the connector conductive case
at the 4213; to the frame ground
at the data source

Interfaces

two parallel interfaces:
1-1