Insert The Avaya™ S8300 Media Server (If Necessary For Standalone Service Or Lsp) - Avaya G700 Installation And Upgrades

2 Installing Hardware for the G700 Media Gateway and S8300 Media Server: Insert the Avaya™ S8300 Media
Server (If Necessary for Standalone Service or LSP)
4. Tighten the mounting screws. Avoid overtightening.
Verify that ventilation vents are not obstructed.
5.
6. Repeat to add other G700 Media Gateways to the rack as described in the planning documents.
End
If you are installing multiple G700s, continue building the stack. Up to 10 units can be linked together
(Figure 13); these may be G700s or Avaya P330 family switches.
At this point, you have mounted the G700 chassis in the rack and are ready to insert S8300 Media
Servers and Media Modules as required in the planning documentation.
Insert the Avaya™ S8300 Media Server
(If Necessary for Standalone Service or LSP)
The S8300 Media Server is inserted into the G700 Media Gateway slot #1 (v1), whether it is the primary
server or configured as a Local Survivable Processor (LSP). The S8300 can only be inserted in the slot (v1)
on the left side of the G700 Media Gateway. The LED module must be pulled from its housing to provide
clearance for the S8300 Media Server.
!
CAUTION:
If you are removing an S8300, use the shutdown button to stop the operating system. The
OK to Remove LED will flash while the shutdown is in progress and will turn steady green
when it is safe to remove the S8300.
Insert the S8300 into Slot #1 of the G700 Media Gateway
Begin
Clear the left side of the G700 Media Gateway.
1.
a . Remove the blank plate from slot #1.
b . Then, disengage the LED module and remove it from the G700 Media Gateway.
Line up the Avaya S8300 Media Server module squarely with its bay opening.
2.
Figure 7. Clear the left side of the G700 Media Gateway
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
49