Migrating From A Definity Ecs R Or Si; Verifying Hardware - Avaya S8500 Manual

Migrating from a DEFINITY ECS R or SI

Migrating from a DEFINITY ECS R or SI
These procedures explain how to migrate an existing DEFINITY ECS R or SI to the Avaya S8700 or
S8710 IP Connect configuration. In this migration, you cannot reuse the existing cabinets; you must
move the reusable circuit packs to Avaya G650 Media Gateways.
At this point
•
The S8700 or S8710 Media Server complex is installed, configured, and operational
•
The G650 Media Gateways are installed
•
Any new port circuit packs that were ordered are installed in the media gateways.
This section covers the following tasks:
•

Verifying hardware

•
Powering down the cabinets
•
Removing the circuit packs
•
Placing circuit packs into G650 Media Gateway
•
Connecting trunks to PSTN
•
Connecting the G650 Media Gateways to the Main Distribution Frame
•
Connecting to the media server
•
Postmigration administration
Verifying hardware
Make sure you have the migration specific hardware on hand. See
Hardware, on page 90 for a list of required hardware. Not all circuit packs can be reused in the G650
Media Gateway.
that can be used with the Avaya G650 Media Gateway.
Modules, on page 93 lists the circuit packs that cannot be used with the Avaya G650 Media Gateway.
In addition, at a presale site inspection, the remediation process must check the vintages of every circuit
pack that will be reused and replace those circuit packs that have unusable vintages. See the Hardware
and Software Compatibility Matrix
ftp://ftp.avaya.com/incoming/Up1cku9/tsoweb/media/minhardwarevintages.pdf).
Table 7: Required Migration Hardware 1 of 2
Comcode
700260359
700263502
700276389
90
NOTE:
This section applies to the S8700 or S8710 IP-Connect configuration only.
on page 90
on page 95
on page 96
on page 97
on page 97
on page 107
Table 8, Allowable Circuit Packs and Circuit Modules,
Description
TN2312BP IP Server Interface circuit pack
IPSI adapter
Maintenance cable (attaches to IPSI adapter—optional)
on page 97
Table 7, Required Migration
Table 9, Non-Allowable Circuit packs and Circuit
Migrating to the Avaya S8700 or S8710 Media Server
on page 97
on page 91 lists the circuit packs
Number
1
1
1
June 2004