Figure 29: Preset Table With Absolute Positions - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Setup | Single steps for setup
Creating a preset table
You can access the preset table on the status bar. The preset table contains the
absolute positions of the presets with respect to the reference mark. You can save
a maximum of 99 datums in the datum table.
3

Figure 29: Preset table with absolute positions

1 Designation
2 Coordinates
3 Edit preset table
Defining presets
You can define the preset table in the following ways:
Name
Probing
Touch-off
Numerical
input
Depending on the application, users of the type Operator define the
presets.
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
1
Description
Probing of a workpiece with a HEIDENHAIN KT 130 edge
finder. The unit automatically transfers the presets into the
preset table
Probing a workpiece using a tool. You must define the respec-
tive tool position manually as a preset
You must manually enter the numeric value of the preset in the
preset table
2
8
145