Example 1: Setting A Preset On A Corner - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Manual operation | Defining presets
10.3.3

Example 1: Setting a preset on a corner

The following probing steps are necessary in order to set the preset on a corner of
the workpiece:
Probing
function
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
steps
Probe the edge in the Y+ direction
Probe the edge in the X+ direction
Probe the edge in the Z– direction
The product defines the preset on the
corner of the workpiece
Figure
10
175