Settings (Oem Area); 15.6.15 Program Execution - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Settings | Service

15.6.14 Settings (OEM area)

Settings ► Service ► OEM area ► Settings
Path:
Parameters
Application
Override display
Keyboard theme
Program run
Text database
Messages

15.6.15 Program execution

Settings ► Service ► OEM area ► Settings ► Program run
Path:
Parameter
Automatic advance on reaching
upper spindle sleeve final
position
M functions
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
Explanation
The type of application mode; a change becomes active after a
restart
Settings:
Milling
Turning
Default value: Milling
Type of override display in Manual mode and MDI
Settings:
Percent: The override is displayed as a percentage of the set
maximum feed rate
Value: Override is displayed in mm/min
Default value: Percent
Selection of the keyboard layout
Settings:
Standard: Confirm the input with (Return)
TNC: entry confirmed with (Enter)
Default value: Standard
Modifying of the program execution
Further information: "Program execution", Page 279
Text database with message texts that are used for OEM-specif-
ic messages
Further information: "Text database", Page 280
Definition of OEM-specific messages
"Messages", Page 281
Further information:
Explanation
Automatic advance when executing hole patterns always occurs
when the upper spindle sleeve limit switch is reached
Settings: ON or OFF
Default value: OFF
For the configuration, see "Configuring M functions", Page 280
15
279