Configuring Axis+ Nc - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

7
Parameters for Spindle axis type
Path:
Start-up time for upper spindle speed range
Start-up time for lower spindle speed range
Break point of characteristic curve for start-up times
Minimum spindle speed
Further information:
Parameters for Spindle with orientation axis type
Path:
Start-up time for upper spindle speed range
Start-up time for lower spindle speed range
Break point of characteristic curve for start-up times
Minimum spindle speed
Kv factor P
Kv factor L
Further information:
Parameters for Gear spindle axis type
Path:
Name
Smax
Start-up time for upper spindle speed range
Start-up time for lower spindle speed range
Break point of characteristic curve for start-up times
Minimum spindle speed
Further information:
Further information:
7.7.6

Configuring Axis+ NC

Depending on the setup of the connected machine tool, you can configure various
parameters for your NC-controlled axes.
110
Settings ► Axes ► Spindle axis S
"Spindle axis S", Page 263
Settings ► Axes ► Spindle axis S
"Spindle axis S", Page 263
Settings ► Axes ► S ► Gear stages
"Adding Gear stages", Page 269
"Gear stages", Page 270
Tap Settings in the main menu
Tap Axes
Tap <Axis name> or Not defined, if applicable
Tap Axis type
Select Axis+ NC (software option)
To switch to the previous display, tap Back
If applicable, select the name of the axis from the Axis name
drop-down list
Commissioning | Configuring the axes
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020