Programming The Tool; Programming The Bolt Hole Circle - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

9
9.9.2

Programming the tool

9.9.3

Programming the bolt hole circle

164
Quick Start | Programming a bolt hole circle and row of holes (programming)
Tap Add block on the toolbar
A new block is inserted below the current position
In the Block type drop-down list, select the Tool call block
type
Tap Tool number
The Tools dialog box appears
Tap Drill 6.1
The associated tool parameters are applied automatically
The Tools dialog box is closed
Tap Add block on the toolbar
A new block is inserted below the current position
In the Block type drop-down list, select the Spindle speed
block type
In Spindle speed, enter the value 3000
Confirm the entry with RET
Tap Add block on the toolbar
A new block is inserted below the current position
In the Block type drop-down list, select the Bolt hole circle
block type
Enter the following values:
Number of holes: 8
X coordinate of center: 0
Y coordinate of center: 0
Radius: 25
Starting angle: 0°
Stepping angle: full circle
Depth: -25
If the tool axis is NC-controlled, additionally enter the
following parameters:
Clearance height: 10
Feed rate: 2000
Feed rate for plunging: 600
Confirm each entry with RET
Tap END to terminate the input process
Tap Save program in the program management
The program is saved
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020