Machine Functions; Machining Pattern - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

13
13.2.3

Machine functions

You can call machine functions to machine the workpiece.
The available functions depend on the configuration of the connected machine
tool. The following blocks and parameters are available:
Block type
Spindle speed
Feed rate
Tool call
M function
Dwell time
13.2.4

Machining pattern

You can define various machining patterns to machine complex shapes. From the
data you enter, the product calculates the geometry of the machining patterns and
optionally displays them in the simulation window.
208
Parameter / Description
Rotational speed of the tool spindle
Speed of the tool axis (only for an NC-controlled axis)
Number of the tool
Optional: Selection from tool table
Further information:
When a tool call is run, the spindle is automatically
stopped and the user is requested to load the corre-
sponding tool.
Number of the M function
Optional: Selection from function table
Time interval between machining steps
Before defining a machining pattern, you must
Define a suitable tool in the tool table
Select the tool on the status bar
"Creating a tool table", Page 143
Further information:
You can load the current axis position with Actual position capture into
the appropriate input fields.
If the program does not contain a Feed
rate block, the product uses the maximum
machine speeds that are given in the menu.
Further information: "Special settings",
Page 249
"Selecting a tool", Page 181
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
Programming | Block types