15.5.12 Encoder - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

15
Parameters
Minimum dwell time in position-
ing window
Coupled main axis
Calculation type with main axis

15.5.12 Encoder

Path:
Settings for encoders with interfaces of the EnDat 2.2 type
Parameter
Encoder input
Interface
ID label
Diagnosis
Encoder model
252
Settings ► Axes ► <Axis name> ► Encoder
Explanation
The entered required amount of time for the axes to be in the
positioning window until the block is completed
Setting range: 0 ms to 10000 ms
Default value: 0 ms
For axes of the Coupled axis type:
Selecting the principal axis to be coupled with the axis
Default value: None
For axes of the Coupled axis type:
Calculation type for the position values of the principal (main)
axis and coupled axis
Settings:
+: The position values are added (principal axis + coupled
axis)
-: The position values are subtracted (principal axis – coupled
axis)
Default value: +
Explanation
Assignment of the encoder input to the axis of the product
Settings:
Not connected
X1
X2
X3
X4
X5
X6
Further information: "Device overview", Page 47
Automatically detected EnDat interface type
Information about the encoder that was read out from the
electronic ID label
Results of encoder diagnostics
Connected encoder model
Settings:
Linear encoder: Linear axis
Angle encoder: Rotary axis
Angle encoder as linear encoder: Rotary axis is displayed as
linear axis
Default value: Depending on the connected encoder
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
Settings | Axes