Overview; General Information - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

5
5.1

Overview

This chapter describes the Installation of the product. It contains information about
the product's connections and instructions about how to correctly connect the
peripheral devices.
5.2

General information

Interference from sources of high electromagnetic emission!
Peripheral devices, such as frequency inverters or servo drives, may cause
interference.
To increase the noise immunity to electromagnetic influences:
Use the optional functional ground connection as per IEC/EN 60204-1
Use only USB peripherals with continuous shielding, e.g. by metalized film
and metal braiding or a metal housing. The degree of coverage provided by
the braiding must be 85 % or higher. The shield must be connected around
the entire circumference of the connectors (360° connection).
Damage to the device from the engaging and disengaging of connecting
elements during operation!
Damage to internal components may result.
Do not engage or disengage any connecting elements while the unit is under
power
Electrostatic discharge (ESD)!
This device contains electrostatic sensitive components that can be destroyed
by electrostatic discharge (ESD).
It is essential to observe the safety precautions for handling ESD-sensitive
components
Never touch connector pins without ensuring proper grounding
Wear a grounded ESD wristband when handling device connections
46
The following steps must be performed only by qualified personnel.
"Personnel qualification", Page 29
Further information:
NOTICE
NOTICE
NOTICE
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
Installation | Overview