Figure 49: Example - Mdi Block; Figure 50: Example - Execution Of An Mdi Block With Scaling Factor - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

MDI mode | Applying the Scaling factor
Example:
The following MDI block is programmed:
Figure 49: Example – MDI block
A Scaling factor of –0.5 is activated for the X axis. The following MDI block will
therefore be executed:
Figure 50: Example – Execution of an MDI block with scaling factor
If the calculated dimensions cannot be attained with the selected tool,
the execution of the block is aborted.
The scaling factor cannot be changed during execution of a block.
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
11
195