Determine the setting dimensions for T2
Touch the measuring diameter with the tool
Touch the measuring diameter with the tool
Retract the tool in Z direction
Enter the touched
measuring diameter in
Measuring point
coordinate X
Press the Take over X soft
key
Touch the end face with the tool
Touch the end face with the tool
Retract the tool in X direction
Enter the value 0 (position of
workpiece datum) for the
measuring point
coordinate Z
Press the Take over Z soft
key
Conclude measurement of
tool T2:
Press the Back soft key
HEIDENHAIN MANUALplus 4110 Tool Measurement
5.9