Defining Presets - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

10
10.3

Defining presets

You can define presets on a workpiece in the Manual Operation mode in the
following ways:
Probe a workpiece with a HEIDENHAIN KT 130 Edge Finder. Use this method
to automatically enter the presets into the preset table.
Probing a workpiece with a tool (touch-off). Use this method to define the
respective tool position as a datum.
Move to the position and set it as a preset, or overwrite position value
Requirement:
A workpiece is clamped on the machine tool
The axes have been homed
172
The setup engineer (Setup) may have already made settings in the
datum table.
Further information: "Creating a preset table", Page 145
When touching the workpiece with a tool, the product uses the
parameters stored in the tool table.
"Creating a tool table", Page 143
Further information:
Manual operation | Defining presets
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020