Coupling Axes - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

7
7.7.7

Coupling axes

If you couple axes with each other, the product offsets the position values of the
two axes according to the selected calculation type. The position display shows
only the principal axis with the calculated position value. Coupled axes are not
shown in the position display.
Further information:
112
Tap Settings in the main menu
Tap Axes
Tap <Axis name> or, if applicable, Not defined for the axis
you wish to couple with a principal axis
Tap Axis type
Select the Coupled axis axis type
To switch to the previous display, tap Back
Select the desired principal axis from the Coupled main axis
drop-down list
Select the desired calculation type from the Calculation type
with main axis drop-down list:
+: principal axis + coupled axis
-: principal axis - coupled axis
The position values of both axes are offset against each other
according to the selected type of calculation
"<Axis name> (settings of the axis)", Page 250
Commissioning | Configuring the axes
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020