HEIDENHAIN POSITIP 8000 Operating Instructions Manual page 264

15
Parameters
Axis type
Outputs
Inputs
Gear stages
Gear stage selection through an
external signal
Start-up time for upper spindle
speed range
Start-up time for lower spindle
speed range
Break point of characteristic
curve for start-up times
Minimum spindle speed
Maximum spindle speed for
oriented spindle stop
264
Explanation
Definition of the axis type
Settings:
Not defined
Axis
Spindle
Gear spindle
Spindle with orientation
Default setting: Spindle
Configuration of the Outputs for the spindle
"Outputs (S)", Page 266
Further information:
Configuration of the Inputs for the spindle
Further information: "Inputs (S)", Page 267
Configuration of the Gear stages for the Gear spindle
Further information: "Gear stages", Page 270
Selection of the Gear stages of the Gear spindle via external
signals
Settings
ON: Selection of the Gear stages is performed via external
signals
OFF: Selection of the Gear stages is performed manually in
the operating modes
Default value: OFF
Setting the Start-up time from standstill to the maximum
spindle speed Smax for the upper spindle speed range
Setting range: 50 ms ... 10000 ms
Default value: 500
Setting the Start-up time from standstill to the maximum
spindle speed Smax for the lower spindle speed range
Setting range: 50 ms ... 10000 ms
Default value: 500
Definition of the limit between the upper and the lower spindle
speed range
Setting range: 0 rpm ... 2000 rpm
Default value: 1500
Definition of the minimum spindle speed
Setting range: 0 rpm ... 500 rpm
Default value: 50
Definition of the maximum spindle speed for oriented spindle
stop
Setting range: 0 rpm ... 500 rpm
Default value: 30
To use the function, you have to assign an input to the
Spindle position parameter.
Further information:
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
Settings | Axes
"Inputs (S)", Page 267