Determining The Preset (Manual Operation Mode); Figure 36: Example Workpiece - Finding Preset D2 - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

9
9.8

Determining the preset (manual operation mode)

To align the bolt hole circle and frame of holes you must set the circle center of
the fit as the preset. Based on this preset the product then calculates all values for
the relative coordinate system. Ascertain the preset with the HEIDENHAIN KT 130
Edge Finder.
Figure 36: Example workpiece – finding preset D2
Activation
Probing preset D2
162
Quick Start | Determining the preset (manual operation mode)
D2: 0/0
Tap Manual operation in the main menu
The user interface for manual operation is displayed
On the machine tool, insert the HEIDENHAIN KT 130 Edge
Finder into spindle and connect to the product
Further information: "Configuring a touch probe", Page 98
Tap Auxiliary functions in the status bar
Tap Find circle center in the dialog
The Select the tool dialog box opens
In the Select the tool dialog, activate the Using touch-
probes option
Follow the instructions of the wizard
Move the edge finder toward the workpiece edge until the
red LED on the edge finder lights up
The Select preset dialog box opens
Retract the edge finder from the workpiece edge
In the Selected preset field, select preset 1
In the Set position values field, enter the value 0 for position
value X and position value Y and confirm with RET
Tap Confirm in the wizard
The probed coordinates are loaded in preset 1
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020