Example 2: Setting A Preset Centered On An Edge - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

10
10.3.4

Example 2: Setting a preset centered on an edge

The following probing steps are necessary in order to set the preset centered on
the edge of the workpiece:
Probing
function
176
steps
Probe the edge in the Y+ direction
Probe the edges in the X+ direction
and X– direction
Probe the edge in the Z– direction
The products defines the preset
centered on the edge of the
workpiece
Manual operation | Defining presets
Figure
1
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
2
M