Figure 55: Schematic Display Of The Bolt Hole Circle Block - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

13
Bolt hole circle block

Figure 55: Schematic display of the bolt hole circle block

Parameter
Number of holes
X coordinate of
center
Y coordinate of
center
Radius
Starting angle
Stepping angle
Depth
Clearance height
Feed rate
Feed rate for plung-
ing
210
Description
Number of holes
Center of the bolt hole arc in the X plane
Center of the bolt hole arc in the Y plane
Radius of the bolt hole arc
Angle of the 1st hole of the bolt hole arc
Angle of the circle segment
Default: bolt hole circle
Target depth for drilling in the Z plane
Default: Through-hole drilling (not available for an NC-
controlled Z axis)
Starting depth for milling in the tool axis (only for NC-
controlled Z axis)
Traversing speed of the tool axis (only for NC-controlled
Z axis)
Traversing speed of the tool axis for plunging (only for
NC-controlled Z axis)
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
Programming | Block types