Figure 57: Schematic Display Of The Rectangular Pocket Block - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

13
Parameter
Feed rate for plung-
ing
Rectangular pocket block

Figure 57: Schematic display of the rectangular pocket block

Parameter
Clearance height
Depth
X coordinate of
center
Y coordinate of
center
Side length in X
Side length in Y
Direction
212
Description
Traversing speed of the tool axis during plunging (only
for NC-controlled Z axis)
Description
Z plane above the workpiece in which the tool is
allowed to move at maximum speed; corresponds to
the starting position and the end position in the NC-
controlled tool axis
Target depth for milling in the tool axis
Default: Through-hole drilling (not available for an NC-
controlled Z axis)
Center of the rectangular pocket in the X plane
Center of the rectangular pocket in the Y plane
Length of the rectangular pocket in the X-axis direction
Length of the rectangular pocket in the Y-axis direction
Direction in which the rectangular pocket is roughed
out (clockwise or counterclockwise)
Default: counterclockwise
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
Programming | Block types