Figure 54: Schematic Depiction Of The Hole Block - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Programming | Block types
Hole block
Z

Figure 54: Schematic depiction of the Hole block

Parameter
X
Y
Depth
Clearance height
Feed rate
Feed rate for plung-
ing
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
Description
Center point of the hole in the X plane
Center point of the hole in the Y plane
Target depth for drilling in the Z plane
Default: Through-hole drilling (not available for an NC-
controlled Z axis)
Starting depth in the tool axis (only for an NC-controlled
Z axis)
Speed of the tool axis (only for an NC-controlled Z axis)
Speed of the tool axis for downfeed (only for an NC-
controlled Z axis)
13
209