Creating A Program; Figure 58: Example Of A Program In The Programming Operating Mode - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Programming | Block types
Parameter
Finishing allowance
Starting depth
Plunging depth
Feed rate for milling
Feed rate for plung-
ing
When machining a rectangular pocket in MDI and Program Run modes of
operation, the following applies:
Approaching the starting position is at clearance height at rapid traverse
If a target depth was defined, positioning is at Clearance height at the end of
the machining operation
13.3

Creating a program

A program always consists of a program header and a sequence of blocks. You
can define various block types, edit the associated block parameters, and delete
individual blocks from the program.

Figure 58: Example of a program in the Programming operating mode

View bar
1
Simulation window (optional)
2
3 Block parameters
4 Toolbar
5 Program blocks
6 Program management
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
Description
Amount of material that is to be left remaining around
the rectangular pocket and will be removed in the last
pass
Starting depth for milling in the tool axis (only for NC-
controlled Z axis)
Plunging depth in the tool axis (only for NC-controlled Z
axis)
Traversing speed of the tool axis during milling (only for
NC-controlled Z axis)
Traversing speed of the tool axis during plunging (only
for NC-controlled Z axis)
1 2 3
6
4
5
213
13