15.5.14 Reference Point Displacement - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

15
Parameters
Inversion of reference mark
pulses
Reference point displacement

15.5.14 Reference point displacement

Path:
Parameters
Reference point displacement
Reference point displacement
Current position for reference
point shift
256
Settings ► Axes ► <Axis name> ► Encoder ► Reference marks ►
Reference point displacement
Explanation
Specifies whether the reference mark pulses are evaluated in
inverted form
Settings
ON: Reference pulses are evaluated in inverted form
OFF: Reference pulses are not evaluated in inverted form
Default value: OFF
Configuration of the offset between the reference mark and the
zero point
Further information: "Reference point displacement",
Page 256
Explanation
Activation of offset calculation between reference mark and
datum of the machine
Setting range: ON or OFF
Default value: OFF
Manual input of the offset (in mm or degrees according to the
selected encoder type) between reference mark and datum
Default value: 0.00000
Apply applies the current position as an offset (in mm or
degrees, depending on the selected encoder model) between
the reference mark and the zero point
HEIDENHAIN | POSITIP 8000 | Operating Instructions Milling | 03/2020
Settings | Axes