Table of Contents
Advertisement
a.
Check that the power cord is the type required in the region where
you use the server. Do not modify or use the supplied AC power cord
if it is not the correct type.
b.
Attach the female end of the power cord to the mating AC power
receptacle on the right-hand side of the server back panel. Plug the
male end of the AC power cord into the AC power source (wall
outlet).
5
Configure the COM1 serial port as the communication port for the
connected maintenance terminal. Configure the COM 1 baud rate for the
serial port on the server to 9600 b/ps. See Avaya Linux Platform Base and
Applications Installation and Commissioning (NN43001-315).
6
Configure the connected maintenance terminal. See Avaya Linux
Platform Base and Applications Installation and Commissioning
(NN43001-315).
7
Press the Power switch.
lnstalling a Signaling Server
End of Procedure
51C to CS 1000M SG CP PIV Upgrade
Page 169 of 198
Advertisement
Table of Contents
