Avaya Communication Server 1000M Series Upgrade page 96

Page 96 of 198 Performing the upgrade
Install the CP card cage in Core 0
Table 15
Core module ID switch settings (System Utility card)
Core 0
Core 1
NN43021-459 Standard 05.04
Procedure 20
Installing the CP card cage in Core 0
1 Check that the card cage is configured as Core 0. See Table 15 for
instructions.
Position 1
On
Off
2 For AC-powered systems only, install the new MPDU, which is part of the
CP PIV Upgrade kit, to the side on the NT4N40 card cage. The screws
that secure the MPDU are accessible from the power supply slot. See
Figure 23.
Figure 23
Location of the screws for the MPDU
MPDU
wall inside
power supply
slot
Note: Pre-thread the two bottom mounting screws at the back of the
Core/Net shelf.
3 Check that the power harness at the right rear corner of the card cage has
been transferred from the old card cage to the CP card cage.
March 2012
Position 2
On
On
back plane
MPDU
mounting screws
card cage
553-5890