Table of Contents
Advertisement
Figure 51
CP PM BIOS automatic upgrade
7
Verify that the BIOS upgrade is finished. Press Enter to reboot.
8
During the reboot memory check, press Ctrl c to access the CP PM BIOS
setup menu.
Note: If you miss the timing to press Ctrl c you must reboot the system
and try again. The Linux Platform Base installation software will display a
warning if you do not reset the CP PM BIOS to factory defaults.
9
Figure 52 appears. Select Reset CMOS to factory defaults from the
menu.
lnstalling a Signaling Server
51C to CS 1000M SG CP PIV Upgrade
Page 179 of 198
Advertisement
Table of Contents
