Table of Contents
Advertisement
Page 102 of 198
Relocate network cards to Core/Net 0
Table 16
QPC441 (QPC440) 3PE Card installed in the CP PIV Core/Net modules
Jumper Settings: For F/FE5 vintage set Jumper RN27 to "A"; for GE5 vintage set Jumper J5 to
short pins 1(dot) & 2.
Switch Settings
Module
CP PIV Core/Net modules only
Core/Net 0 (Shelf 0)
Core/Net 1 (Shelf 1)
NN43021-459
Standard 05.04
Performing the upgrade
Procedure 22
Relocating Network cards to CP Core 0
1
Remove all network cards from the previous Core 0 Core/Net shelf
2
When you move the 3PE card, check the switch settings and jumpers.
See Table 16.
a.
All 3PE cards must be vintage F or later.
b.
Check that the RN27 Jumper is set to "A" (F/FE5 vintage) or J5
jumper shorts pins 1(dot) & 2 (GE5 vintage).
c.
The settings for 3PE cards in Core/Net shelves are different from
those in all other shelves: Table 16 shows the 3PE settings for cards
installed in CP PIV Core/Net Modules.
3
Reinstall each removed card in the same network slot in the CP PIV Core/
Net 0.
4
Connect the tagged cables to the relocated cards.
Group 0
Group 0
March 2012
D20 switch position
1
2
3
off
on
on
off
on
on
End of Procedure
4
5
6
off
on
on
off
on
on
7
8
on
on
on
off
Advertisement
Table of Contents
