Table of Contents
Advertisement
Page 92 of 198
Performing the upgrade
NN43021-459
Standard 05.04
17 Remove the power harness and reserve it for reinstallation as part of
installing the NT4N40 card cage. The power harness is located at the right
rear lower corner and plugs into the rear of the power supply.
•
For AC systems, relocate power harness NT8D40.
•
For DC systems, relocate power harness NT7D11.
WARNING
Be sure to perform the following step. If you do not tape
the EMI shield in position, you cannot install the card
cage in the module correctly.
18 Reposition the EMI shield (it looks like a brass grill) in the base of the
module. Tape over the front mounting tabs to hold the shield in position.
You will remove the tape later.
CAUTION
Damage to Equipment
Check for and remove any debris (such as screws) that
could have fallen into the base of the UEM module.
March 2012
End of Procedure
Advertisement
Table of Contents
