Firmware Update; Ivu Trigger, Remote Teach, And I/O Waveforms; Pnp (Low-To-High) Trigger And Remote Teach Input Waveforms; Npn (High-To-Low) Trigger And Remote Teach Input Waveforms - Banner iVu Plus TG Series Instruction Manual

11.9 Firmware Update

Main Menu > System > Firmware Update
Use the Firmware Update screen to load the latest device firmware. The Firmware Update screen lists the firmware versions
it finds in the BANNER\FIRMWARE folder on the USB flash drive. When you receive a firmware update from Banner
Engineering, be sure to put it in the BANNER\FIRMWARE folder on the USB flash drive.
Note: The Firmware Update menu is not available in the Emulator.

11.10 iVu Trigger, Remote Teach, and I/O Waveforms

The iVu has two input signals—Trigger and Remote Teach. The default setting is to detect the low to high transition. To
change this setting, go to Main Menu > System > Discrete I/O > Input Polarity on the iVu.
11.10.1 PNP (Low-to-High) Trigger and Remote Teach Input
Waveforms
Wire Color
Pink
Gray
The iVu triggers from low to high, and Remote Teach behaves electrically like trigger.
Note:
Table 15: Required iVu Input Signal Voltage
PNP
11.10.2 NPN (High-to-Low) Trigger and Remote Teach Input
Waveforms
Wire Color
Pink
Gray
The iVu triggers from high to low, and Remote Teach behaves electrically like trigger.
Power up
Function
Trigger
Remote
Teach
+10 V dc to 30 V dc
Power up
Function
Trigger
Remote
Teach
www.bannerengineering.com - Tel: + 1 888 373 6767
iVu Plus TG and Color Gen2 Image Sensors
ON OFF
< 2 V dc
73