Installing A Filter On An Ivu - Banner iVu Plus TG Series Instruction Manual

iVu Plus TG and Color Gen2 Image Sensors
Pin # Wire Color
7 Blue
8 Red
9 Orange
10 Light Blue
11 Black
12 Violet

4.3 Installing a Filter on an iVu

Installing a Filter on the Micro Video Lens Model
To install a filter on the iVu with Micro Video Lens, use the illustration as a guide and follow the steps listed below.
CAUTION: Failure to follow these instructions may cause damage to your iVu.
CAUTION: Electrostatic Discharge
Avoid the damage that electrostatic discharge (ESD) can cause to the Sensor.
Always use a proven method for preventing electrostatic discharge when installing a lens or attaching a
cable.
Note: Filter kits are available separately.
1. Remove the locking screw (D) using the 1/16-inch hex key.
Note: The locking clip (C) inserts in a groove near the top of the focusing window (B). When
removing the window, the locking clip will be loose. Do not to lose the clip while removing the
window.
2. Unscrew the focusing window by turning it clockwise approximately 5 complete turns or until the focusing window
disengages from the light/lens assembly.
Note: The light/lens assembly may include an integrated ring light or a blank disk if an integrated
ring light is not used. Be careful that the light/lens assembly does not pull out when removing the
focusing window. Pull gently on the focusing window. If the lens assembly moves with the
window, continue to rotate the window clockwise until the lens assembly does not move.
3. Set the focusing window aside. Do not to get any debris on the window's O-ring.
4. If present, remove the protective covering on the filter.
18
Description
Common (Signal Ground)
Ready
Output 3
RS-232 TX
RS-232 Signal Ground
RS-232 Rx
A Lens
B Focusing Window
C Locking Clip
D Locking Screw
E Filter Cap
F Filter
Figure 10. Micro Video Lens Model Components
www.bannerengineering.com - Tel: + 1 888 373 6767
Direction
Input
Output
Output
Output
Output
Input