Vision Manager; Connect To The Sensor - Banner iVu Plus TG Series Instruction Manual

iVu Plus TG and Color Gen2 Image Sensors

5 Vision Manager

Connect to the iVu using Vision Manager PC Software to control the device remotely. After connecting to the device, the
interface displays on the Sensor tab. Use the interface in the same manner as the iVu display.
Vision Manager is not required to configure or run the iVu.

5.1 Connect to the Sensor

These instructions use Windows
1. Confirm the network connections.
a) Click the Start button, then on the Start menu, click Control Panel.
b) In Control Panel, click Network and Internet, then click Network and Sharing Center, and then click Change
adapter settings.
c) Right-click on the connection that you want to change, then click Properties.
If you are prompted for an administrator password or confirmation, enter the password or provide confirmation.
d) In the connection properties, click Internet Protocol Version 4 (TCP/IPv4), and then click Properties.
e) In the Internet Protocol (TCP/IPv4) Properties, select Use the following IP address.
f) Make sure that the IP address is 192.168.0.2, and the subnet mask is 255.255.255.0.
2. Open Vision Manager from the desktop or the Start menu.
The Sensor Neighborhood tab displays and lists the available sensors.
3. From Sensor Neighborhood, click
The status changes from Available
from the sensor.
4. If the desired sensor is not listed, verify that:
• The network adapter connected to the sensor has the same subnet mask as the sensor (for example,
192.168.0.xxx); view the subnet mask in the Network Adapters list at
Network Adapters
• The Ethernet cable is the correct type
• The TCP/IPv4 settings are correct
Or, manually enter the sensor's IP address.
Note: The sensor's IP address and subnet mask are also available from the sensor display.
7
Windows is a registered trademark of Microsoft Corporation in the United States and/or other countries.
20
®
operating system version 7, 8, or 10.
Figure 13. Local Area Connection Properties
to connect to the desired sensor.
to Connected
www.bannerengineering.com - Tel: + 1 888 373 6767
7
and the Sensor screen displays. Click
Home > Sensor Neighborhood >
to disconnect