Motion Menu - Banner iVu Plus TG Series Instruction Manual

iVu Plus TG and Color Gen2 Image Sensors
Color Select
Main Menu > Inspection > Sensors > ColorArea > Color Select
Use Color Select to select the color the Color Area sensor looks for. Click
the ROI. Adjust the color tolerance using + and -.
Note: You can select a color that is outside of the ROI, but a BLOB of that color will only be detected
within the ROI.
Area Range
Main Menu > Inspection > Sensors > [Sensor Type] > Area Range
Use Area Range to set the size limits of a feature of interest. Move the slider to select the range. Areas are measured by
counting pixels. For example, a rectangular feature that is 100 pixels wide by 200 pixels tall has an area of roughly 20,000
pixels.
Pass Count
Main Menu > Inspection > Sensors > [Sensor Type] > Pass Count
The Minimum Pass Count is the minimum number of parts, labels, or features expected to fall within the specified criteria.
The Maximum Pass Count is the maximum number expected to fall within the specified criteria. These settings are used to
determine the pass or fail result of the inspection.
Pass Total Area
Main Menu > Inspection > Sensors > [Sensor Type] > Pass Total Area
Use Pass Total Area to set the desired total area of all features that the sensor must find in order to pass the inspection.
Move the slider to select the range. Areas are measured by counting pixels. For example, a rectangular feature that is 100
pixels wide by 200 pixels tall has an area of roughly 20,000 pixels. Two features of this size have an area of roughly 40,000
pixels.
Tolerance
Main Menu > Inspection > Sensors > ColorArea > Tolerance
Adjust the tolerance for the color the sensor is looking for. Adjustments are made individually for hue, saturation, and
intensity.

9.2 Motion Menu

Main Menu > Inspection > Motion
Enable Motion when the part being inspected is expected to move or rotate. Motion settings for Edge involve selecting the
number of edges to locate, adjusting sensitivity, and selecting whether rotation is enabled. Motion settings for Match
involve selecting the Teach ROI type, adjusting the percent match and rotation range, editing the taught pattern, and setting
a timeout. These settings are available on the Inspection Menu after Motion is set to Edge or Match.
Motion is not available for Sort sensors.
Edge Options
• Number of Edges
• Sensitivity
• Rotation Range
48
Match Options
•
•
•
•
•
•
www.bannerengineering.com - Tel: + 1 888 373 6767
Color Selector then click the desired color in
Teach ROI Type
Percent Match
Rotation Range
Edit Pattern
Advanced
Timeout