Save To Usb; Load From Usb; Reset To Defaults; System Information - Banner iVu Plus TG Series Instruction Manual

11.2.1 Save to USB

Main Menu > System > Configuration > Save to USB
The Save to USB screen allows the device configuration to be saved to a USB flash drive. The saved configuration
information can be used as a backup or to clone configuration information for other devices.
Note: On the Emulator, this option is Save Configuration.

11.2.2 Load from USB

Main Menu > System > Configuration > Load from USB
The Load from USB screen allows the device configuration to be restored from a USB flash drive. This operation removes
all existing inspections and replaces them with inspections contained in the configuration file on the USB flash drive.
Note: On the Emulator, this option is Load Configuration.

11.2.3 Reset to Defaults

Main Menu > System > Configuration > Reset to Defaults
Resets the device to factory default state:
• All existing inspections are deleted
• All imager and system settings are reset to factory defaults
• For color models, white balance settings are reset to the factory defaults
• Device-specific information such as the sensor name and Ethernet settings are not changed
• System Log information is retained
The device reboots after this operation is complete.

11.3 System Information

Main Menu > System > Information
The Information screen displays device information:
• Serial Number
• Firmware Version
• Boot Number
• Up Timer—the time elapsed since last boot up of the device
• Hour Count—the total hours of operation in the device's lifetime
• Model Number
• Device Name
Click the right-arrow next to Device Name to display a keyboard that allows you to change the name of the device. You may
set the device name in English on the device. To set the device name in any other language, use the Emulator.

11.4 Lock Device

Main Menu > System > Lock Device
Figure 68. Reset to Defaults Screen
www.bannerengineering.com - Tel: + 1 888 373 6767
iVu Plus TG and Color Gen2 Image Sensors
59