Communications Menu; Ethernet I/O - Banner iVu Plus TG Series Instruction Manual

iVu Plus TG and Color Gen2 Image Sensors
Lock the device to prevent accidental modification of settings. When locked, the device only provides access to pass/fail
statistics, as well as the ability to view logs and to save them to a USB device. A lock icon in the upper left corner of the
display indicates that the device is locked.
The device can be locked with or without a password. If a password is not used, click Unlock Device to unlock the device.
When a password is used, it must be 4 digits entered using the keypad. If the password is lost, contact Banner Engineering
to obtain a Reset Key.
Note: This menu option is not available in the Emulator.

11.5 Communications Menu

Main Menu > System > Communications
Use the Communications menu to configure the serial I/O channel. There are six menu options:
• Ethernet I/O for configuring the Ethernet port
• Serial I/O for configuring the Serial port
• Industrial Ethernet settings
• Command Channel for sending commands to get specific data through Serial or Ethernet channels.
• Data Export Channel for enabling or disabling the channel for data export only
• Image Export Channel for enabling or disabling the channel for image export only
Note: Serial I/O can be configured either for Data Export or Command Channel. Image Export is only
available on Ethernet.

11.5.1 Ethernet I/O

Main Menu > System > Communications > Ethernet I/O
Use Ethernet communications to send data out the Ethernet port as part of an inspection, and so that remote devices can
communicate with the iVu. Configure the IP Address, Subnet Mask, and Gateway settings from the Ethernet I/O screen. Use
the expand arrow next to each field to display a keypad to enter values for each field. Click Status to verify communications
as you connect to remote devices.
60
Figure 69. Communications Menu
Figure 70. Ethernet I/O Screen
www.bannerengineering.com - Tel: + 1 888 373 6767