Display Icons; Communications Log Icons - Banner iVu Plus TG Series Instruction Manual

8.1.2 Display Icons

Icon Description
The Inspection Passed icon is located in the upper-left of the display. This icon indicates that the last
inspection passed the test conditions.
One of the possible Inspection Failed icons located in the upper-left of the display. This icon indicates that
the last inspection failed.
One of the possible Sensor Failed icons located in the Inspection Statistic table. This icon indicates that
the sensor failed because the number of objects exceeded the test count.
One of the possible Sensor Failed icons located in the Inspection Statistic table. This icon indicates that
the sensor failed because there were fewer objects than specified by the test count.
One of the possible Sensor Failed icons located in the Inspection Statistic table. This icon indicates that
the sensor failed because the inspection timed out.
One of the possible Inspection Failed icons located in the upper-left of the display. This icon indicates that
the sensor is in fail hold mode.
The Device Locked icon is located in the upper-left of the display. This icon indicates that the device is in a
locked state. If no icon is displayed, the device is unlocked.

8.1.3 Communications Log Icons

Icon Description
Port open.
Port closed.
Indicates that the command has been processed without errors.
Indicates that the incoming entry is stalled (no new bytes), or end-of-frame delimiter was not received, or
client is not reading data on Ethernet.
Indicates whether the response frame contains an error or is dropped, the log entry icons for the request
and the response frames are red, and the displayed error count increments by one.
If the command takes a long time to process, the last long entry changes to an hourglass (for example,
during trigger of long inspections).
www.bannerengineering.com - Tel: + 1 888 373 6767
iVu Plus TG and Color Gen2 Image Sensors
37