Device System Menu; Mode; System Configuration Menu - Banner iVu Plus TG Series Instruction Manual

iVu Plus TG and Color Gen2 Image Sensors

11 Device System Menu

Main Menu > System
The System menu icon is on the Main Menu, and is used to manage the iVu device. From the System menu, select the
Mode, update the device firmware, back up or restore the device configuration, and perform other general system level
operations.

11.1 Mode

Main Menu > System > Mode
The iVu has two operating modes:
• Live Mode, which is the normal operating mode where the iVu captures live images, scans, and verifies inspections
• Demo Mode, where inspections are run on stored images and inspection parameters
The first time the iVu is powered up, it starts in Demo Mode. You can choose whether to stay in Demo Mode or exit to Live
Mode. Demo Mode uses stored images and inspection parameters that demonstrate how the iVu is set up, without having
to worry about focus, lighting, or triggers. In this mode, practice making adjustments while working with the different sensor
types and observing how the adjustments affect the results. To exit Demo Mode, go to Main Menu > System > Mode and
select Exit Demo Mode. Upon exit, the iVu restarts in the normal operating mode with the default settings.
Note: Switch between Live Mode and Demo Mode any time by going to Main Menu > System > Mode.

11.2 System Configuration Menu

Main Menu > System > Configuration
The Configuration screen allows users to save configurations, load new configurations, or reset the device to default values.
The configuration options are:
• Save to USB—Save the device configuration to a USB flash drive
• Load from USB—Load the device configuration from the USB flash drive
• Reset to Defaults—Reset the device configuration to defaults
58
Figure 66. System Menu
Figure 67. Configuration Menu
www.bannerengineering.com - Tel: + 1 888 373 6767