Installation Enable Of The Servosignalanalyzer - Parker Compax3 Series Operating Instructions Manual

Setting up Compax3
4.3.9.3
Please observe:
250

Installation enable of the ServoSignalAnalyzer

In this chapter you can read about:
Prerequisites.................................................................................................................... 250
Installation........................................................................................................................ 250
Activation ......................................................................................................................... 250
Prerequisites
Compax3 with up-to-date controller board (CTP 17)
Firmware version R06-0 installed
Installation
Execution of the C3 ServoManager Setup (on CD)
If the firmware is too old => update with the aid of the firmware from the CD
Activation
In order to being able to use the analysis functions in the frequency range (for ex-
ample frequency response measurement), a software activation is required.
The activation is only valid for the PC on which it was performed!
Caution! : If the PC disposes of network adapters which are removed at times (e.g.
PCMIA cards or notebook docking stations), these adapters should be removed
before generating the key!
In order to activate the ServoSignalAnalyzer, please follow these steps:
Start the Compax3 ServoManager.
192-120114 N5 C3I22T11 June 2008
C3I22T11