Setting up Compax3
4.4.9.3
Please observe:
196
Installation enable of the ServoSignalAnalyzer
In this chapter you can read about:
Prerequisites....................................................................................................................................196
Installation........................................................................................................................................196
Activation .........................................................................................................................................196
Prerequisites
Compax3 with up-to-date controller board (CTP 17)
Firmware version R06-0 installed
Installation
Execution of the C3 ServoManager Setup (on CD)
If the firmware is too old => update with the aid of the firmware from the CD
Activation
In order to being able to use the analysis functions in the frequency range (for
example frequency response measurement), a software activation is required.
The activation is only valid for the PC on which it was performed!
Caution! : If the PC disposes of network adapters which are removed at times (e.g.
PCMIA cards or notebook docking stations), these adapters should be removed
before generating the key!
In order to activate the ServoSignalAnalyzer, please follow these steps:
Start the Compax3 ServoManager.
192-120101 N11 C3I11T11 November 2007
Positioning via digital I/Os