Settings For Channels 1 - Parker Compax3 Series Operating Instructions Manual

Setting up Compax3
164
For the operatiing modes SINGLE, NORMAL and AUTO, the following XDIV
time settings are possible:
XDIV Mode Scanning time Samples DIV/TOTAL
0.5ms 1 125us
1.0ms 2 125µs
2.0ms 3 125µs
5.0ms 4 125µs
10.0ms 5 125µs
20.0ms 6 250µs
50.0ms 7 625µs
100.0ms 8 1.25ms
200.0ms 9 2.50ms
500.0ms 10 6.25ms
1s 11 12.50s
2s 12 25.00ms
5s 13 62.50ms
10s 14 125.00ms
For the operating ROLL, the following XDIV time settings are possible:
XDIV Mode Scanning time Samples DIV/TOTAL
2 ms 54 125us
2ms 54 125µs
4ms 55 125µs
10ms 56 125µs
20ms 57 125µs
40ms 58 125µs
100ms 59 250µs
200ms 60 625µs
Changing the time basis is also permitted during an OSCI measuring sequence.
This means, however, that the current measurement is interrupted and started
again with the changed settings.

Settings for channels 1..4

1: Select channel color
2: Open menu for channel-specific settings
Reset Channel CH 1..4 all channel settings are deleted.
Please note: Channels can only be fileld with sources one after the other. It is, for
example, not possible to start a measurement which has only a signal source for
channel 2!
Select channel color: Here you can change the color of the channel..
show/hide channel: Hide/show display of the channel.
Change logic display mask: Mask bits in logic display.
auto scaling Calculation of YDIV and Offset: The program calculates the best
settings for YDIV and channel offset in order to display the complete signal va-
lues optimally.
192-120114 N5 C3I22T11 June 2008
4/40
8/80
16/160
40/400
80/800
80/800
80/800
80/800
80/800
80/800
80/800
80/800
80/800
80/800
200/2000
200/2000
200/2000
200/2000
200/2000
200/2000
200/2000
200/2000
C3I22T11
Measuring time
5ms
10ms
20ms
50ms
100ms
200ms
500ms
1s
2s
5s
10s
20s
50s
100s