Remote Diagnosis Via Modem; Structure - Parker Compax3 Series Operating Instructions Manual

Parker EME
5.3

Remote diagnosis via Modem

In this chapter you can read about:

Structure ...........................................................................................................................305

Configuration of local modem 1........................................................................................306
Configuration of remote modem 2 ....................................................................................307
Recommendations for preparing the modem operation ...................................................308
Caution!
5.3.1. Structure
As the transmission via modem may be very slow and interference-prone, the
operation of the Compax3 ServoManager via modem connection is on your
The function setup mode as well as the ROLL mode of the oscilloscope are
not available for remote diagnosis!
It is not recommended to use the logic analyzer in the Compax3 IEC61131-3
debugger due to the limited bandwidth.
Requirements:
For modem operation, a direct and stable telephone connection is required.
Operation via a company-internal telephone system is not recommended.
Layout and configuration of a modem connection ServoManager -
Compax3:
PC
Compax3
ServoManager
konfig
Modem 1
1 2
konfig
Release < R5-0
Compax3.ini
192-120114 N5 C3I22T11 June 2008
own risk!
machine
Compax3
5
3
konfig
Modem 2
Phone
X10
SSK31
4
konfig
Release < R4-5
PC (115200Baud)
ATE0 cr
10 11
ATQ1 cr
Hyper-
terminal
Communication
PC
Release
> R5-0
7
Compax3
konfig
ServoManager
konfig
9
6 8
Release
> R4-5
< R5-0
305