4.3.10. Profileviewer For The Optimization Of The Motion Profile; Mode 1: Time And Maximum Values Are Deduced From Compax3; Input Values - Parker Compax3 Series Operating Instructions Manual

Parker EME

4.3.10. ProfileViewer for the optimization of the motion profile

In this chapter you can read about:
Mode 1: Time and maximum values are deduced from Compax3 input values..............285
Mode 2: Compax3 input values are deduced from times and maximum values ..............286
4.3.10.1
You will find the ProfileViewer in the Compax3 ServoManager under the "Tools"
Menu:

Mode 1: Time and maximum values are deduced from Compax3

input values

The motion profile is calculated from Position, Speed, Acceleration, Deceleration,
Acceleration Jerk and Deceleration Jerk
As a result you will get, besides a graphical display, the following characteristic
values of the profile:
Times for the acceleration, deceleration and constant phase
Maximum values for acceleration, deceleration and speed
192-120114 N5 C3I22T11 June 2008
Setting up Compax3
285