Replacing Expansion Cards; Preliminary Steps; Removing An Expansion Card - Fujitsu PRIMERGY TX1310 M3 Upgrade And Maintenance Manual

9.3.3

Replacing expansion cards

Upgrade and Repair Unit
(URU)
Tools: Only for installing or removing slot brackets:
– Phillips PH2 / (+) No. 2 screw driver
– Hexagon nut 5 mm (for hexagon bolt)
Note on network settings recovery
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
network controller or the system board.
9.3.3.1

Preliminary steps

"Suspending BitLocker functionality" on page 61
Ê
"Shutting down the server" on page 44
Ê
"Disconnecting the power cord" on page 45
Ê
"Getting access to the component" on page 46
Ê
9.3.3.2

Removing an expansion card

Ê Remove the defective expansion card, see section
card" on page
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the expansion card, see section
page 112.
TX1310 M3
117.
Upgrade and Maintenance Manual
Expansion cards and backup units
Hardware: 5 minutes
Software: 5 minutes
"Removing an expansion
"Removing a slot bracket" on
119