Replacing Expansion Cards; Preliminary Steps; Removing An Expansion Card - Fujitsu PRIMERGY TX1320 M4 Upgrade And Maintenance Manual

Expansion cards and backup units
9.4.3

Replacing expansion cards

Upgrade and Repair Unit
(URU)
Phillips PH2 / (+) No. 2 screw driver (only for replacing the slot
Tools:
bracket)
Note on network settings recovery
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
network controller or the system board.
9.4.3.1

Preliminary steps

"Locating the defective server" on page 47
Ê
"Suspending BitLocker functionality" on page 67
Ê
Ê If applicable, ensure to note down your current network settings.
"Shutting down the server" on page 49
Ê
"Disconnecting the power cord" on page 50
Ê
Ê If applicable, disconnect external cables from the expansion card.
"Getting access to the component" on page 51
Ê
"Locating the defective component" on page 48
Ê
9.4.3.2

Removing an expansion card

Ê Remove the expansion card, see section
page 188.
Ê If the slot bracket on the defective expansion card is to be used again,
remove it from the expansion card, see section
page 174.
190 Upgrade and Maintenance Manual
Hardware: 5 minutes
Software: 5 minutes
"Removing an expansion card" on
"Removing a slot bracket" on
TX1320 M4